MITSUBISHI ELECTRIC MR-J2S- CL - Manual (Page 311)

15 - 14
15. COMMUNICATION FUNCTIONS
15.11.2 Write commands
(1) Status display (Command [8][1])
Command Data No. Description Setting range Frame length
[8][1] [0][0] Status display data clear 1EA5 4
(2) Parameter (Command [8][4])
Command Data No. Description Setting range Frame length
[8][4]
[0][0] to
[5][A]
Each parameter write
The decimal equivalent of the data No. value
(hexadecimal) corresponds to the parameter number. Depends on
the parameter. 8
(3) External I/O signal (Command [9][2])
Command Data No. Description Setting range Frame length
[9][2] [6][0]
Communication input device signal Refer to
Section 15.12.5
8
(4) Alarm history (Command [8][2])
Command Data No. Description Setting range Frame length
[8][2] [2][0] Alarm history clear 1EA5 4
(5) Current alarm (Command [8][2])
Command Data No. Description Setting range Frame length
[8][2] [0][0] Alarm reset 1EA5 4
(6) General-purpose register (Rx) value (Command [B][9])
Command Data No. Description Setting range Frame length
[B][9] [0][1] The value of the general-purpose register (R1)
[B][9] [0][2] The value of the general-purpose register (R2)
[B][9] [0][3] The value of the general-purpose register (R3)
[B][9] [0][4] The value of the general-purpose register (R4)
Depends on
the used
instruction.
4
(7) General-purpose register (Dx) value (Command [B][A])
Command Data No. Description Setting range Frame length
[B][A] [0][1] The value of the general-purpose register (D1)
[B][A] [0][2] The value of the general-purpose register (D2)
[B][A] [0][3] The value of the general-purpose register (D3)
[B][A] [0][4] The value of the general-purpose register (D4)
Depends on
the used
instruction.
4