MK Diamond Products MK CX-3 - Manual (Page 15)

MK CX-3 Revision 09/04, Effective Date September 17, 2004 Page 15
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
SETUP:
1. Pre-start Inspection:
The pre-start inspection should be performed before beginning any job.
If Diamond Blade is worn, replace the blade before starting work.
(E)
Verify the CX-3 rolls freely
(D)
Verify the Height Adjusting
Wheel moves freely and the CX-3
moves up and down smoothly
(C)
Inspect the MK CX-3 for
general damage and/or loose
hardware
(F)
Check for proper oil level
(See Maintenance section if low)
(B)
Inspect Engine for leaks
(H)
Check Air Filter for cleanliness
(See Maintenance section
if dirty)
(G)
Check for proper fuel level
(See Maintenance section if low)
Fill Throat
Upper Limit Air Filter
(A)
Inspect Blade for damage – Verify
Blade correct for material being
cut
Look for leaks
Verify ease of
movement
Verify ease of
movement
Proper Oil Level
Low Level