MK Diamond Products MK CX-3 - Manual (Page 12)

MK CX-3 Revision 09/04, Effective Date September 17, 2004 Page 12
UNPACKING, TRANSPORT and ASSEMBLY
(D)
Place the Blade Shaft Wrench
onto the flat section of the Blade
Shaft
Shaft
Wrench
Shaft
(E)
Loosen the Blade Retaining Screw
while holding the Shaft Wrench
steady
Retaining Nut
Wrench
Shaft
Wrench
(F)
Remove the Blade
Retaining Screw
Retaining Nut
Removed
(G)
Remove the Outer Flange
Outer
Flange
(H)
Install the Diamond Blade onto the
Blade Shaft
Diamond
Blade
(I)
Verify the direction of rotation
arrow of the Blade matches the
direction of rotation on the CX-3
Rotational
Arrow
(J)
Install the Outer Flange
Outer
Flange
(K)
Verify the Outer Flange is seated
against the Blade
Flush Against
Blade
Outer
Flange
Blade
(L)
Install the Blade Retaining Screw
Retaining
Screw