Gefen DVI MATRIX EXT-DVI-16416 - Manual (Page 32)

28
RS-232 / TELNET / UDP COMMANDS
#sipadd Command
The #sipadd command sets the IP address of the matrix. Dot-decimal notation must be
used when specifying the IP address.
Syntax:
#sipadd param1
Parameters:
param1
IP address
Notes:
The matrix must be rebooted after executing this command.
Example:
#sipadd 192.168.1.239
New IP set to: 192.168.1.239
#snetmask Command
The #snetmask command sets the IP network mask. Dot-decimal notation must be used
when specifying the IP network mask.
Syntax:
#snetmask param1
Parameters:
param1
Network mask
Notes:
The matrix must be rebooted after executing this command.
Example:
#snetmask 255.255.255.0
New IP Mask set to: 255.255.255.0