Gefen DVI MATRIX EXT-DVI-16416 - Manual (Page 30)

26
RS-232 / TELNET / UDP COMMANDS
#set_udp_rip Command
The #set_udp_rip command sets the remote UDP IP address. The default port
value is 8.
Syntax:
#set_udp_rip param1
Parameters:
param1
IP Address
Notes:
The matrix must be rebooted after executing this command.
Example:
#set_udp_rip 192.168.1.20
New remote UDP IP address set to: 192.168.1.20
#set_udp_rport Command
The #set_udp_rport command sets the remote UDP port.
Syntax:
#set_udp_rport param1
Parameters:
param1
Port
Notes:
The matrix must be rebooted after executing this command.
Syntax:
#set_udp_rport 4096
New remote UDP port set to: 4096