Garmin HN294DP/DI - Manual (Page 91)

Important Information
EN/LZT 108 6377 R4 - September 2003 85
EN 300328-2 V1.2.1:2001
11.3.3.1 FCC Part 15 Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules (Code of
Federal Regulations Title 47, Telecommunications (CFR 47)). These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with these instructions, may
cause harmful interference to radio or television reception. However, there
is no guarantee that interference will occur in particular installation. If this
equipment does cause harmful interference to radio or television, which can
be determined by turning the equipment off and on, the user is encouraged
to eliminate the interference by one or more of the following measures:
Reorient or relocate the receiving antenna of the affected
equipment.
Increase the separation between the ADSL Router WLAN HN294d
and the affected equipment.
Connect the ADSL Router WLAN HN294d power supply to an outlet
on a circuit different from that to which the affected equipment is
connected.
Consult your service provider or an experienced radio/TV technician
for help.
11.3.3.2 FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed an
operated with a minimum distance of 2.5 cm between the radiator and your
body. This device must not be co-located with any other antenna or
transmitter.
11.3.4 Telecom Approval
The HN294d is approved according to the following telecom standard: