Garmin HN294DP/DI - Manual (Page 49)

Advanced Configuration
EN/LZT 108 6377 R4 - September 2003 43
Parameter Description
PVC Name The name specified for the specific PVC.
VPI Shows the VPI (Virtual Path Identifier). Valid range
is from 0 to 255.
VCI Shows the VCI (Virtual Channel Identifier). Valid
range is from 32 to 4095 (1-31 is reserved for well-
known protocols).
Data Encap Shows the ADSL mode connection type (RFC1483
Bridged, RFC1483 Routed, RFC1483 MER, PPPoA
or PPPoE) and the selected encapsulation type (VC-
MUX or LLC/SNAP).
NAT Shows if NAT (Network Address Translation) is
enabled.
Local WAN IP Shows the IP address your HN294d will use on the
Internet.
9.5.3 Traffic Counter
The Status > Traffic Counter page shows the records of data going
through the LAN, WLAN and WAN interfaces.
For each interface, cumulative totals are displayed for Transmitted (Tx) /
Received (Rx) packets and Transmitted (Tx) / Received (Rx) bytes.
By clicking the Refresh link (above the table) all the values will be updated.