GarrettCom 6K32 User Manual

Page 56

Magnum 6K32 Managed Switch Installation and User Guide (02/05)

www GarrettCom com

5.2.11a GBIC-LXSC Gigabit fiber (1000Mb), multi-mode SC Connector

The Magnum GBIC-LXSC is a single-mode Gigabit fiber connector equipped

with SC type connectors and can be easily snapped in and out. The Gigabit fiber ports are

most popular as server-to-switch and switch-to-switch applications. It supports cable

distances up to the IEEE 802.3z standard 1000Mbps distance limits, i.e., 10,25, 40 or

70Km at full duplex, and depend upon the Gigabit modules used.

1@ 1000Mb Fiber SC + 2@ 100Mb SC

The two Giga port has been offered as GBPM-2OTX (fiber or RJ-45), whereas the single

Gigabit module comes in flavor of G+4(10/100 RJ-45 ports) or G+2 (100Mb fiber ports)

as shown below in the above figure.

Each port has an Activity (ACT) LED indicating packets being received and a link (LK)

LED indicating proper connectivity with the remote device when lit.

5.2.12 6KM-BLNK

The 6K8-BLNK is a blank face plate or cover plate that must be installed in

any empty 6K32 PM slot to

maintain proper cooling air

flow, safety, etc.

Two

screws

underneath the front panel hold

the 6KM-BLNK in place.

6.0 TROUBLESHOOTING

All Magnum Ethernet products are designed to provide reliability and

consistently high performance in all network environments. The installation of a

Magnum 6K32 Switch is a straightforward procedure (see INSTALLATION, Section

3.0); the operation is also straightforward and is discussed in Section 4.

Should problems develop during installation or operation, this section is

intended to help locate, identify and correct these types of problems. Please follow the

TX RX

ACT

LK RX

ACT

TX RX

ACT