Grizzly G0503 - Manual (Page 40)

Model G0503 (Mfg. Since 12/08) -38-
5. dry the filter base to remove any excess
hydraulic fluid.
6. rub clean grease on the filter gasket and
screw the new filter into the filter base.
7. tighten the filter by hand until the gasket
contacts the base—then tighten another full
turn.
8. plug in the resaw and start the conveyor
belt.
9. inspect the hydraulic system for leaks.
Tools Needed Qty
wrench/socket 17mm ....................................... 1
wrench/socket 10mm ....................................... 1
drain pan 20 gal ............................................... 1
Supplies Needed Qty
iso Vg 46 hydraulic Fluid ........................14 gal
solvent ...................................................... Varies
To drain the hydraulic fluid:
1. Disconnect the resaw from the power
source!
2. with your drain pan in place, remove the
drain plug shown in figure 50 and allow the
tank to completely drain.
Hydraulic System
Major Service
a major service consists of performing a “Minor
service,” plus draining the fluid, cleaning the tank
and screen, and filling the tank with new fluid.
The hydraulic fluid is hot and under high
pressure when the hydraulic pump motor is
running. Always stop the resaw, make sure
the pressure gauge reads 0 pSI, and make
sure the fluid is cool before servicing.
figure 50. hydraulic tank drain plug.
figure 49. hydraulic fluid filter.
To change the filter:
1. Read and understand the hydraulic safety
instructions on page 11 before continu-
ing!
2. Disconnect the resaw from the power
source!
3. thoroughly clean the area around the filter to
prevent contamination of the hydraulic fluid.
4. remove the filter shown in figure 49.
replacement filter kits can be ordered
from grizzly industrial using part number
p0503B74.
Filter pressure
gauge
hydraulic
Fluid Filter
drain plug