Grizzly G0503 - Manual (Page 38)

Model G0503 (Mfg. Since 12/08) -36-
Tools Needed Qty
grease gun ....................................................... 1
Hardware Needed Qty
high temp Bearing grease ...................... Varies
Multi-purpose grease ............................... Varies
wipe grease fittings clean and lubricate with two
pumps of high-temp bearing grease. to lubricate
a greased surface; wipe the surface clean and
apply a thin coating of multi-purpose grease.
the photos in figure 47 label the grease fit-
tings and greased surfaces by number for easy
identification. Match the numbers in
figure 47
to the chart below for proper greasing intervals.
note—This page was designed to be copied and
used as a check-off chart to help maintain a regu-
lar lubrication schedule.
Greasing
5
G0503 GREASE SCHEDULE/CHECK-OFF CHART
Main Wheels
Blade Tension Slide
conveyor
Elevation Shaft
Elevation Gear
Tension Handle
1,2
3,
4,5,6
7,8
9
10
(see fig. 47 for
fitting locations)
1
3
6
7
8
4
9
10
2
figure 47. lubrication points.