Grizzly G0503 - Manual (Page 18)

Model G0503 (Mfg. Since 12/08) -16-
Gasoline and petroleum
products have low flash
points and could cause
an explosion or fire if
used to clean machinery.
DO NOT use gasoline or
petroleum products to
clean the machinery.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest-
ed. Lack of ventilation
while using these sol-
vents could cause seri-
ous personal health risks
or fire. Take precautions
from this hazard by only
using cleaning solvents
in a well ventilated area.
clean up
the wheels and the blade guides of the Model
g0503 are coated with a light coat of grease to
protect them from corrosion during shipment.
remove the blade guard for complete access
to the blade guides and clean off the protective
coating with a solvent or citrus-based degreaser
such as grizzly’s g7895 degreaser shown on
page 32. avoid chlorine-based solvents, such as
acetone or brake cleaners, as they may damage
painted surfaces. always follow the manufactur-
er’s instructions when using any type of cleaning
product.
after the wheels and guide block assemblies
have been cleaned, coat them liberally with a
metal protectant and reinstall the blade guard.
For metal protectants, we recommend using
g96
® gun trEatMEnt or BoEshiEld ® t-9
shown on page 32.
Items Needed
for Set up
ITEM QTy
Forklift ............................................................... 1
Citrus-Based degreaser or solvent .......... Varies
Metal protectant ........................................ Varies
hammer drill ..................................................... 1
air Compressor ................................................. 1
Vacuum ............................................................. 1
punch
1 ⁄
2
" ........................................................... 1
hammer drill bit 1 ⁄
2
" X 6" .................................... 1
hammer ............................................................ 1
lag shields
5 ⁄
16
" x 3" .......................................... 6
lag Bolts 5 ⁄
16
" x 4" ............................................. 6
Flat washers 5 ⁄
16
" .............................................. 6
assistants .......................................................... 3
dust Collector (1500 CFM min.) ........................ 1
dust Collection hoses 4" .................................. 3
hose Clamps 4" ................................................ 3
protective gloves .......................................1 pair
locking power disconnect lever...................... 1
Conduit ...................................................... Varies
Conduit Connectors .......................................... 2
power Cord or wires...................... see
page 12