Grizzly G0503 - Manual (Page 24)

Model G0503 (Mfg. Since 12/08) -22-
figure 18. dust hoses connected to dust ports.
to be effective, the dust collection system that
you connect to the resaw must be able draw a
minimum of 1500 CFM at the point where you
connect the hoses to the resaw. note—This
number is an approximation and has been pro-
vided for estimation purposes only.
Tools Needed Qty
phillips head screwdriver ................................ 1
Hardware Needed Qty
dust Collection hoses 4" .................................. 3
hose Clamps ..................................................... 6
dust Collector .................................................... 1
To connect the resaw to a dust collector:
1. attach a 4" dust hose to all three dust ports
as shown in figure 18, and be sure to tight-
en the hose clamp to ensure a snug fit.
connecting to the
Dust collector
Blade installation can be done by one person but
is easiest if done with two people.
Hardware Needed Qty
resaw Blade ..................................................... 1
To install the blade:
1. Disconnect the resaw from the power
source!
2. put on protective gloves.
3. open the wheel covers for access to the
wheels.
4. hold the blade from each side, and position
it in front of the wheels so the blade teeth are
facing the front of the machine, as shown in
figure 19.
These instructions present
a serious injury hazard if
done while the machine
is connected to power. DO
NOT connect to power until
instructed!
figure 19. positioning blade for installation.
Installing the Blade
2. attach all three dust hoses to a dust collec-
tion system with hose clamps.