Grizzly G0503 - Manual (Page 25)

Model G0503 (Mfg. Since 12/08) -23-
figure 20. Blade positioned between guides.
figure 21. illustration of proper blade position.
6. position the blade on the wheels so the tooth
gullet is approximately 1 ⁄
16
" over the edge of
the wheel as illustrated in figure 21.
5. Carefully fit the blade over each wheel,
and position it between the blade guides
as shown in
figure 20. Make sure the
teeth point toward the right-hand side of the
machine, as you are facing the front.
figure 22. Blade tensioning handle.
8. turn the wheels clockwise by hand.
—if the blade remains centered, does not
touch any guides, and the support bearing
is approximately 0.016" behind the back of
the blade, continue on to Connecting to the
Power Source.
—if the bottom of the blade gullets do not
remain centered on the wheels, then turn
to Tracking on
page 40 for adjustment
instructions.
—if the blade rubs on the blade guides, turn
to Adjusting the Blade Guides on page 42
for adjustment instructions.
—if the support bearing turns when the blade
is rotated, go to Adjusting the Support
Wheel on
page 43 for adjustment instruc-
tions.
set plate
sleeve
7. hand tighten the handle until the set plate
comes in contact with the sleeve shown in
figure 22.