Grizzly G0503 - Manual (Page 30)

Model G0503 (Mfg. Since 12/08) -28-
the blade height is the distance between the
conveyor table and the bottom of the blade.
Blade Height
figure 28. Blade elevation handwheel.
NOTICE
The resaw blade may come into contact
with the conveyor belt if lowered below 1 ⁄
4
".
To set the blade height:
1. Disconnect the resaw from the power
source!
2. turn the blade elevation handwheel (shown
in figure 28) counterclockwise to raise the
blade or clockwise to lower the blade. use
the elevation gauge to determine the height.
note: Six rotations of the handwheel raises the
blade approximately
1 /
4
".
3. Connect the resaw to power and cut a test
piece.
4. Measure the test piece to ensure the thick-
ness matches the elevation gauge reading.
—if the wood thickness is different than
indicated on the elevation gauge, turn to
Blade Elevation Gauge on
page 43 for
adjustment instructions.
Blade Elevation
gauge
Blade Elevation
handwheel
conveyor controls
the Model g0503 features a variable speed
infeed conveyor to move lumber through the
blade. slow the conveyor speed to get a smooth
cut on hard wood, and speed it up for softer
woods.
To operate the infeed conveyor:
1. push the puMp start button on the con-
trol panel.
2. push the conveyor on/oFF lever (figure
29) forward (toward the conveyor belt) to
start the conveyor.
figure 29. Conveyor controls.
Conveyor on/oFF
lever
Conveyor
speed dial
3. turn the conveyor speed dial (figure 29)
counter-clockwise to increase the speed or
clockwise to decrease the speed.
4. pull the engagement lever back (away from
the conveyor) to stop conveyor.