Grizzly G0503 - Manual (Page 20)

Model G0503 (Mfg. Since 12/08) -18-
we recommend that you bolt your new resaw to
the floor. Because this is optional and floor mate-
rials may vary, floor mounting hardware is not
included. it may be necessary to level the floor
before installing this machine.
note—The instructions below are given for a typi-
cal heavy-duty shop floor made of 6" thick con-
crete. Also, anchor studs may be substituted for
lag bolts, but they will stick out of the floor if you
decide to move your machine at a later point.
Tools Needed Qty
hammer drill ..................................................... 1
punch
1 ⁄
2
" ........................................................... 1
hammer drill bit 1 ⁄
2
" x 6" .................................... 1
hammer ............................................................. 1
air Compressor ................................................. 1
Vacuum ............................................................. 1
Hardware Needed Qty
lag shields 5 ⁄
16
" x 3" .......................................... 6
lag Bolts 5 ⁄
16
" x 4" .............................................. 6
Flat washer 5 ⁄
16
" ................................................ 6
To mount the resaw machine to the floor:
1. put on safety glasses and a dust mask
before starting!
2. use the mounting holes in the resaw stand
feet to act as a guide for drilling into your
floor, and drill approximately 3
1 ⁄
2
" deep into
the concrete floor.
3. using compressed air and a vacuum, remove
the concrete dust from the newly drilled
holes.
4. using the hammer and punch, pound the lag
shields into the concrete below the stand feet
and flush with the surface of the concrete.
5. secure the resaw to the floor with the lag
bolts and washers.
Mounting Resaw to
the floor
Mounting the
conveyor Belt
Tools Needed Qty
wrench/socket 17mm ...................................... 1
Hardware Needed Qty
Carriage Bolt M10-1.5 x 30 ............................... 6
Flat washer 10mm ............................................ 6
lock nut M10-1.5 .............................................. 6
To install the conveyor belt onto the resaw:
1. remove the lag bolts that secure the con-
veyor belt assembly to the crate pallet.
2. remove the blade guide (shown in the upper
half of figure 8) from the wheel housing.
The conveyor belt is very
heavy. Seek assistance
or use power equipment
to mount the conveyor
belt.
3. lift the conveyor belt onto the resaw body as
shown in the lower half of figure 8.
figure 8. Conveyor belt placement.