Grizzly G0503 - Manual (Page 31)

Model G0503 (Mfg. Since 12/08) -29-
pressure Rollers
the pressure rollers hold the workpiece against
the conveyor table for a smooth cut.
Tools Needed Qty
hex wrench 5mm ............................................ 1
wrench/socket 17mm ...................................... 2
wrench 35mm .................................................. 1
To adjust the pressure rollers:
1. Disconnect the resaw from power!
2. loosen the jam nuts and hex bolts that
secure the extension arm of the infeed pres-
sure roller (see
figure 30).
figure 30. infeed pressure roller.
3. Extend the pressure roller close to the blade
and tighten the jam nuts and hex bolts. Make
sure the extension arm can rotate without
hitting the pressure roller on the blade.
NOTICE
The blade can move into the infeed pressure
roller when the blade height is changed.
prevent damage by checking the pressure
rollers each time the blade is adjusted.
Extension arm
adjustment Bolts
horizontal
adjustment Bolt
figure 31. pressure roller adjustments.
height adjustment
5. rotate the height adjustment nut to raise or
lower the infeed pressure roller.
—adjust the pressure roller to apply pressure
to the top of the workpiece, but not touch
the table after the workpiece passes.
—when working with thick workpieces,
adjust the pressure roller so the workpiece
does not hit the extension arm before con-
tacting the pressure rollers.
6. if the workpiece hangs up on the outfeed
pressure roller, loosen the set screws shown
in
figure 32, and slide the weight up the
shaft, then tighten the set screws.
figure 32. outfeed pressure roller.
4. loosen the horizontal adjustment bolt indi-
cated in figure 31, center the pressure roll-
ers on the workpiece, then retighten the bolt
and jam nut.
set screw