Grizzly G0503 - Manual (Page 37)

Model G0503 (Mfg. Since 12/08) -35-
to ensure optimum power transmission from the
motor to the blade and to the hydraulic pump,
the V-belts must be in good condition (free from
cracks, fraying and wear) and operate under
proper tension. Check the V-belts at least every
three months; more often if the bandsaw is used
daily.
see Adjusting V-Belt Tension on page 48 for
instructions on properly tensioning the belts or for
replacing the belts, if needed.
Inside Wheel cover
to keep the bandsaw working properly, regularly
open the wheel cover and vacuum any sawdust
from the machine that did not make it into the
dust collector.
Resaw Wheels and Scrapers
use a dry rag to wipe sawdust from the wheel
scrapers. remove sawdust build up on the
wheels by rotating the wheels by hand while hold-
ing the dry rag on the contact surface.
conveyor Belt
use compressed air to clean the built-up sawdust
from the conveyor belt. Eye injuries frequently
occur when cleaning with compressed air—wear
safety glasses to protect yourself! Also wear a
dust mask or respirator to protect your lungs from
airborne dust particles.
painted Surfaces
these areas may be cleaned with a dry or damp
rag; however, make sure you do not clean
bare metal surfaces with a damp rag or they may
rust.
always be aware of the condition of your machine.
routinely check the condition of the following
items and repair or replace as necessary:
• loose mounting bolts
• worn switch
• worn or damaged blade
• worn or damaged support bearings
Always disconnect
power to the machine
before performing main-
tenance. failure to do
this may result in seri-
ous personal injury.
Except for the bearings that are fitted with grease
fittings, the bearings are sealed and pre-lubri-
cated and require no lubrication during their
usable life. all bearings are standard sizes, and
replacements can be purchased from our parts
department or a bearing supply store.
Bearings
v-Belts
Miscellaneous
cleaning
SEcTION 6: MAINTENANcE