Gateway 920 User Manual
User's guide
Table of contents
Document Outline
- Contents
- Checking Out Your Gateway Server
- Setting Up Your Server
- Maintaining Your Server
- Installing Components
- Preparing to install components
- Preventing static electricity discharge
- Opening the server case
- Closing the server case
- Installing drives
- Installing memory
- Installing PCI expansion cards
- Replacing the processor
- Replacing the power supply
- Replacing the system board
- Replacing the case fan
- Replacing the CMOS battery
- Using the BIOS Setup Utility
- Troubleshooting
- Telephone support
- Tutoring and training
- Safety guidelines
- Error messages
- Diskette drive 0 seek to track 0 failed
- Error loading operating system
- Hard disk controller failure
- Hard disk controller failure - press F1 to try reboot
- Insert bootable media device
- Invalid configuration information
- Invalid partition table
- Invalid password
- Memory errors were detected while the system started up
- Memory size error
- Missing operating system
- System Event Log Full
- Troubleshooting
- First steps
- Battery replacement
- Beep codes
- BIOS
- CD or DVD drive
- Diskette drive
- Expansion cards
- Hard drive
- The hard drive cannot be accessed, or you receive a “General failure reading drive C” error message
- You receive a “Non-system disk” or “disk error” error message
- Your server does not recognize an IDE drive
- Your server does not recognize a SCSI drive
- The master boot record is corrupted
- You need to troubleshoot an IDE hard drive
- Internet
- Keyboard
- Memory
- Modem (telephone dial-up)
- Monitor
- Power
- Processor
- Server Specifications
- BIOS Settings
- Safety, Regulatory, and Legal Information
- Index