Gateway 920 - Manual (Page 46)

41
Installing PCI expansion cards
www.gateway.com
5
While holding the retention cover open, remove the expansion card. You
can slightly seesaw the card end-to-end to loosen the card, but do not bend
the card sideways.
6
While holding the retention cover open, press the new card into the
expansion slot. You can slightly seesaw the card end-to-end to help insert
the card, but do not bend the card sideways.
7
Push the retention cover in, then tighten the thumbscrew.
8
Connect any cables to the card. For more information, see the card’s
documentation.
9
Follow the instructions in “Closing the server case” on page 28 .
10
See the card’s documentation for software installation instructions.
Warning Do not touch the contacts on the bottom part of the
expansion card. Touching the contacts can cause
electrostatic damage to the card.