Gateway 920 - Manual (Page 67)

62
Chapter 5: Using the BIOS Setup Utility
www.gateway.com
6
Turn on the server. You can now open the BIOS Setup utility or perform
other server tasks.
If you want to change the passwords, press F2 when the Gateway logo
screen appears. When the BIOS Setup utility opens, you can clear or change
the passwords, or change other BIOS settings.
7
Turn off the server, disconnect the power cord, and remove the side panel
again.
8
Remove the jumper from pins 1-2 of jumper J13 and place it over just one
of the pins for storage.
9
Close the case, reconnect the cords, then turn on the server.