Gateway 920 User Manual
Page 65
60
Chapter 5: Using the BIOS Setup Utility
www.gateway.com
9
Close the case, then reconnect the power cord, monitor, and keyboard. For
more information, see
“Closing the server case” on page 28
10
Turn on the server. A message appears saying that the CMOS Checksum
is bad, which means the BIOS has been cleared successfully.
11
Press F2 to load the default BIOS values and open the BIOS Setup utility.
All BIOS settings return to factory defaults, and all BIOS passwords are
erased.
12
Turn off the server, disconnect the power cord, and remove the side panel
again.
13
Remove the jumper from pins 3-4 of jumper J13 and place it over just one
of the pins for storage.
14
Close the case, reconnect the cords, then turn on the server.
See also other documents in the category Gateway Computers:
- E-2300 (134 pages)
- E-4100 (144 pages)
- ALR 7300 (138 pages)
- E-4650 (134 pages)
- E-6300 (136 pages)
- E-9232T (96 pages)
- 610 (108 pages)
- ProfileTM 5 (292 pages)
- Profile 6 (130 pages)
- E SERIES E-6000 (190 pages)
- SZSL95IN0XXXXXXXX (132 pages)
- 8400 (34 pages)
- DX4800 (94 pages)
- GR380 F1 (17 pages)
- MAN FX510 (150 pages)
- GM5688E (140 pages)
- GR585 F1 (14 pages)
- 6400 (148 pages)
- GM5478 (2 pages)
- 7400 (156 pages)
- E-5250 (46 pages)
- FX6710 (1 page)
- E-9425R (118 pages)
- ALR 7200 (134 pages)
- FX542X (154 pages)
- 7250R (135 pages)
- 7250R (26 pages)
- DX430X (96 pages)
- 8450R (4 pages)
- 8450R (172 pages)
- 7450R (124 pages)
- E-5400 (130 pages)
- E-5200 (46 pages)
- PC (110 pages)
- GR160 F1 (14 pages)
- ALR 8300 (128 pages)
- eMachine 3 (96 pages)
- 9415 (188 pages)
- 980 (131 pages)
- 9210 (106 pages)
- E1400 (136 pages)
- FX542XT (94 pages)
- E3400 (126 pages)
- Media Center (28 pages)
- MT-6733 (3 pages)