Gateway 920 - Manual (Page 40)

35
Installing drives
www.gateway.com
16
If you removed the front cover, replace it.
17
Follow the instructions in “Closing the server case” on page 28 .
Installing a hard drive
To install a hard drive:
1
Follow the instructions in “Preventing static electricity discharge” on
page 25 .
2
Follow the instructions in “Opening the server case” on page 26 .
3
If you are replacing a hard drive, disconnect the old drive’s cables.
4
Slide the drive release latch toward the open side of the case.
Important Drives connected to the primary and secondary IDE
connectors should be ATA100 drives, and drives
connected to the third IDE connector should be ATA66
drives.