Gateway XHD3000 - Manual (Page 56)

CHAPTER 4: Troubleshooting
50
You want to plug in your headphones, but there is a
headphone jack on both sides of the speaker bar.
• You can use either jack or both jacks at the same time.
When headphones are connected, no sound comes out
of the speaker bar’s speakers.
You do not get sound from your headphones.
• Make sure that your speaker bar is connected to an audio
source by unplugging your headphones and adjusting
the speaker bar’s volume.
The sound coming from the speakers sounds distorted.
• Turn down the volume until the distortion disappears.
• Check the audio output volume of the sound device the
speaker bar is connected to. If the audio device’s output
volume is set too high, the speaker bar’s sound may
always be distorted. To adjust the audio device’s output
volume, see the device’s user guide. To adjust the volume
in Windows, click the speaker icon in the Windows
taskbar, or click
(Start), Control Panel, Sounds and
Audio Devices, the Volume tab, then click Advanced.
For optimum volume control using the speaker bar, we
recommend that you set the Windows volume mid-way
between the lowest and highest setting.
HDCP FAQs
What is HDCP and how do I troubleshoot it?
• High-bandwidth Digital Content Protection (HDCP) is a
specification developed by the Intel
®
Corporation to
protect digital entertainment content that uses a digital
visual interface (DVI), including HDMI connections.
HDCP encrypts the transmission of digital content
(signal) between the video source (computer, DVD player,
or set-top box) and the digital display (monitor, digital
television, or projector). HDCP is not designed to prevent
copying or recording of digital content, but only to
protect the integrity of the content as transmitted.
8512322_XHD3000 Usr Gde.book Page 50 Friday, August 10, 2007 12:33 PM