Fostex D-160 - Manual (Page 91)

D-160 Owner's Manual (Edit function)
91
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/16 7/15 6/14 5/13 4/12 3/11 2/10 1/9
RECORD TRACK
HD ACCESS LOCKED MTC IN
END IN OUT START
AUTO PUNCH
AUTO PLAY IN OUT
AUTO RTN
CLIPBOARD
PASTE MOVE COPY
AUTO RTN
ERASE UNDO REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/ STORE RECALL
TIME BASE SEL
TAKE
REHEARSAL LOCATE PUNCH
F FWD REWIND PLAY STOP RECORD
VARI PITCH
LOCATE ABS END
2. Move & Paste
The Move & Paste function “moves” sound data to the Clipboard, and
“pastes” the data in the same track or another track. You can specify the
number of repeats of the paste operation (1-99) to paste data repeatedly.
The difference between the Copy & Paste and the Move & Paste operation
is that, after the Move & Paste operation, the source data and the data on
the Clipboard will be removed. You can use this function with any Time
Base.
* To perform the Move operation, you first need to set the start point (Clipboard In point)
and the end point (Clipboard Out point) of the data to be moved, and the move source
track. To perform the Paste operation, you need to set the start point (Auto Punch In
point) and the paste destination point.
The data on the Clipboard will be replaced by new data each time you press the
COPY key or the MOVE key.
2-1. Moving
First, you need to specify the area to be moved (using the Clipboard In/
Out points and move track).
* The following procedure is based on data with the ABS Time Base.
To change the Time Base to MTC or MIDI BAR/BEAT/CLK, press the DISP SEL key while
pressing and holding down the EXECUTE/YES key.
* Before you start working, restore the default settings on the D-160.
* Do not change Programs or sampling rates until a session is complete.
Entering and storing the CLIPBOARD IN point
1. Press the RECALL key, and then the CLIPBOARD IN key (or press only the
CLIPBOARD IN key). The D-160 will enter the edit mode.
2. Move the cursor to the digit you wish to change using the HOLD/> key or the
SHUTTLE dial, and change the value using the JOG dial.
3. After setting the value, press the STORE key, and then the CLIPBOARD IN key.
The time value will be stored as the Clipboard In time, the edit mode will
disengage, and the display will return to the previous screen.
7 2, 5
1, 3
4, 6
3, 6
1, 4
8