beautypg.com

Explanation on the command/mode set – Fostex D-160 User Manual

Page 179

background image

D-160 Owner's Manual (MMC/FEX List/Maintenance/Specifications)

179

Explanation on the Command/Mode Set

12 22 (): loop on/off command

The command for setting the "loop mode on/off" (=ON/OFF of AUTO RTN) of D-160.
Default figure of the loop operation mode is "12=stop" and this cannot be changed.

12 28 (): post locate command

The command for setting the "post locate mode" (=ON/OFF of AUTO PLAY) of D-160.
It will stop after locating if "post locate mode=12." It will enter play after locating if "post
locate mode=15."

12 2D (): auto rec command

The command for setting "auto rec mode on/off" (=ON/OFF of AUTO PUNCH) of D-160.
Upon receiving this command, D-160 will immediately reply the operating condition by
sending "32 2D ()".

12 41 (): lock enable command

The command for setting "slave mode on/off" (setup menu) of D-160.

12 42 (): lock mode command

The command for setup of the slave mode (setup menu) when this equipment is set to
"slave mode on."

12 45 () : copy clip command

When this command is received, D-160 will copy (multiple number of tracks can be
copied simultaneously) the sound data, as data for copy paste, from the pre-registered
clipboard-in point to the clipboard-out point in the track specified by .
With completion of copying the data into the clipboard, D-160 will immediately reply
with "32 45 ()".
If copy cannot be executed due to improper figures of the pre-registered clipboard in/
clipboard out points or incorrect track section, the corresponding will be
returned.

12 46 (): copy paste command

12 46 (): copy paste command

When this command is received, D-160 will paste the sound data which has been copied
into the clipboard, on the same track from the pre-registered auto punch in point as the
starting point for the number of time specified by .
However, if the sound data length in the clipboard is less than 10ms, the specifying the
will be limited to "01."
Also, by specifying , paste can be executed on other tracks in mono (in one
track units) or stereo units (in combinations of tracks 1&2, 3&4, 5&6.......15 & 16).
Since time corresponding to length of the copy clipped sound data is required to complete
the copy paste operation, D-160 immediately replies with "32 46((active)>)" after receiving the command.
Successively upon completing the paste operation, "32 46 ((completed)>)" is transmitted.
If paste cannot be executed due to improper figures of the pre-registered auto punch in
point, insufficient disc capacity, no sound data in the clipboard, etc., the corresponding
will be replied.

12 47 (): erase command

When this command is received, D-160 will erase the data (writes in "0" data) in the
section from the pre-registered auto punch in point through auto punch out point in the
track specified by . Since time corresponding to length of the erase section
is required to complete the erase operation, D-160 will immediately reply by "32 47