Fostex D-160 - Manual (Page 176)

D-160 Owner's Manual (MMC/FEX List/Maintenance/Specifications)
176
Edit point memory of this equipment is alloted to the response/information field
of 08~0F (GP0~GP7) as shown below.
GP7 however, will be used as the work memory for small adjusting of the
registered figure (Refer to Examples 4 and 5).
08 GP0 : locate memory 09 GP1 : clipboard in memory
0A GP2 : clipboard out memory 0B GP3 : start memory
0C GP4 : auto punch in memory 0D GP5 : auto punch out memory
0E GP6 : end memory 0F GP7 : work memory
[Example 1] is registered in the start memory (using the write command).
F0 7F 06 F7
[Example 2] Locate memory is recalled (using the read command).
F0 7F 06 F7
[Example 3] On-the-fly registering in the punch in memory (using the move command).
F0 7F 06 selected time code = 01> F7
[Example 4] When + 1 frame is to be set in the punch in memory (using the add
command).
* Time figure to be added is pre-registered in GP7 (Set 00h 00m 00s 01f in GP7).
F0 7F 06 (GP4)> F7
[Example 5] When -1 frame is to be set in the punch in memory (using the subtract
command).
* Time figure to be subtracted is pre-registered in GP7 (Set 00h 00m 00s 01f in
GP7).
F0 7F 06
F7