Fostex D-160 - Manual (Page 181)

D-160 Owner's Manual (MMC/FEX List/Maintenance/Specifications)
181
If paste cannot be executed due to improper figures of the previously registered auto
punch in point, insufficient disc capacity, no sound data is in the clipboard, etc., the
corresponding will be replied.
12 4F (): track exchange command (Exclusive command for FDMS-3.)
When the D-160 receives this command, the track can be exchange between the specified
. Especially, if the first , then exchange by grouping
will be executed between channel 1-8 and channel 17-24, and if the next byte ,
then the exchange will be between channel 9-16 and channel 17-24.
If it cannot be executed for some reason, an error message will be sent back.
12 50: all erase current program command (Exclusive command for FDMS-3.)
When the D-160 receives this command, all audio of the current program will be erased
to return it to the initial state of compiling a new program.
As execution of all erase is completed in a comparatively short time, the D-160 will reply
with "32 50 ()" immediately after completion of exchange.
If it cannot be executed for some reason, an error message will be sent back.
13 3E: product new program command (Exclusive command for FDMS-3.)
When the D-160 receives this command, a new program is compiled and the current
program is transferred to the new program.
As compilation of the new program is comparatively short time, it is replied with "33 3E
()" immediately upon completion of execution.
If it cannot be executed for some reason, an error message will be sent back.
13 3F: delete current program command (Exclusive command for FDMS-3.)
When the D-160 receives this command, the current program is deleted and succeeding
programs moved up and renumberd. If the deleted program is the only tune existing in
the track, a new program will be made automatically.
As this delete current program is executed in a comparatively short time, "33 3F (message=01 (completed)>)" will be sent back immediately upon completing the execution.
If it cannot be executed for some reason, an error message will be sent back.
13 41 (): digital in ch.select command
The audio signal input from SPDIF digital in to assigned to the destination track specified
by . The first shown in the command is the SPDIF L channel input,
and the second the R channel input. " " indicates
the normal analog input.
13 41 (): Adat in select command
Channel = 7F indicates that it is Adat In.
Normally, it will be "" and all channels will be inputs from Adat In.
If is indicates, then only the tracks selected will be Adat In inputs.
"" indicates the normal analog input.
13 42 (): digital out ch.select command
The source channel for digital out is selected.
Normally, the first shown will be the SPDIF L channel data, and the second
the SPDIF R channel output.
By FDMS-2 (D-80, DMT-8) in particular, the following five types only can be setup.
(<01><02>), (<03><04>), (<05><06>), (<07><08>), (<00><00>). (<00><00>) is the
default setting. By FDMS-3 (D-160), any channel within "1 ~ 16" can be selected.
13 42 (): Adat out select command
In a device which can be switched between SPDIF and Adat, if the first display is
, then Adat Out can be setup.