Fostex D-160 - Manual (Page 185)

D-160 Owner's Manual (MMC/FEX List/Maintenance/Specifications)
185
24 01 (): signature map request
The command for inquiring the meter setup. Order number counting from the leading
tune must be specified in the event number (The first event is expressed as "event
number=00." When this command is received, this equipment replies with "34 01
()."
24 02 (): Tempo set map request
The command for inquiring tempo data. Order number from the leading tune must be
specified in the event number (The first event is expressed as "event number=00."
When this command is received, this equipment replies with "34 02 ()."
24 04: preroll time status request
The command for inquiring the preroll time setup status.
When this command is received, this equipment replies with "34 04 ()."
24 05: remain time request
The command for inquiring the disk remaining time which is recordable.
When this command is received, this equipment replies with "34 05 ()."
24 06: frame rate status request
The command for inquiring the frame rate setup status.
When this command is received, this equipment replies with "34 06 ()."
24 07: fs rate status request
The command for inquiring the fs (sampling frequency) setup status.
When this command is received, this equipment replies with "34 07 ()."
24 08: time base status
The command for inquiring the setup status of the time base shown in the display.
When this command is received, this equipment replies with "3408 ()."
Explanation on the Status Reply
32 21 (): loop operation mode status repry
This is the reply against the "22 21" loop operation status request command.
is the only status data of D-160 and any other setting is not
permissible.
32 22 (): loop on/off status reply
This is the reply against "22 22" loop on/off status request.
32 28 (): post locate mode status reply
This is the reply against "22 28" post locate status request.
is the only status data of D-160 and any other setting is not permissible.
32 2D (): auto rec status reply
This is the reply against the "12 2D" auto rec command or the "22 2D" auto rec status
request.
32 41 (): lock status repry
This is the reply against the "22 41" lock status request.
32 42 (): lock mode status reply
This the reply against the "22 42" lock mode status request.