Fortinet Version 3.0 - Manual (Page 70)

FortiBridge Version 3.0 Administration Guide
70 09-30000-0163-20061109
system route config CLI commands
system route
Use this command to add or edit FortiBridge static routes.
Command syntax pattern
config system route
edit
set
end
config router static
unset
get system route
show system route
Example
This example shows how to edit a FortiBridge static route.
config system route
edit 2
set dst 192.168.22.0 255.255.255.0
set gateway 192.168.22.44
end
This example shows how to display the list of static route numbers.
get system route
This example shows how to display the settings for static route 2.
get system route 2
This example shows how to display the static route configuration.
show system route
This example shows how to display the configuration for static route 2.
show system route 2
Keywords and variables Description Default
distance The administrative distance for the route. Using administrative
distance you can specify the relative priorities of different routes to the
same destination. A lower administrative distance indicates a more
preferred route. Distance can be an integer from 1-255. 10
dst
address_ipv4mask>
The destination IP address and netmask for this route.
Enter 0.0.0.0 0.0.0.0 for the destination IP address and netmask
to add a default route. 0.0.0.0
0.0.0.0
gateway
address_ipv4>
The IP address of the first next hop router to which this route directs
traffic. No
default.