Fortinet Version 3.0 - Manual (Page 34)

FortiBridge Version 3.0 Administration Guide
34 09-30000-0163-20061109
Installing FortiBridge unit firmware Setting up FortiBridge units
The following message appears:
Enter firmware image file [image.out]:
10 Type the firmware image file name and press Enter.
The TFTP server uploads the firmware image file to the FortiBridge unit and the
FortiBridge unit installs the new firmware image, resets the configuration to factory
defaults, and restarts. This process takes a few minutes.
11 Reconnect to the CLI.
12 To confirm that the firmware image has been loaded, enter:
get system status
Note: The local IP address is a temporary address used to download the firmware image.
The local IP address should be on the same subnet as the TFTP server IP address.