Fortinet Version 3.0 - Manual (Page 54)

FortiBridge Version 3.0 Administration Guide
54 09-30000-0163-20061109
log syslogd setting config CLI commands
log syslogd setting
Use this command to configure the FortiBridge unit to send a syslog message to a remote syslog
server when action on failure is set to send a syslog message.
Command syntax pattern
config log syslogd setting
set
end
config log syslogd setting
unset
get log syslogd setting
show log syslogd setting
Example
This example shows how to enable logging to a remote syslog server, configure an IP address and
port for the server, and enable logging in CSV format.
config log syslogd setting
set status enable
set server 220.210.200.190
set port 601
set csv enable
end
This example shows how to display the log setting for logging to a remote syslog server.
get log syslogd setting
This example shows how to display the configuration for logging to a remote syslog server.
show log syslogd setting
If the show command returns you to the prompt, the settings are at default.
Related Commands
• probe setting
Keywords and variables Description Default
csv {disable | enable} Enable formatting log messages in Comma Separated Value
(CSV) format. If you do not enable CSV format the FortiBridge
unit produces plain text log messages. disable
facility {alert | audit |
auth | authpriv | clock |
cron | daemon | ftp |
kernel | local0 | local1
| local2 | local3 |
local4 | local5 | local6
| local7 | lpr | mail |
news | ntp | syslog |
user | uucp}
Enter the facility type, which identifies the source of the log
message to the syslog server. You might want to change facility
to distinguish log messages from different FortiBridge units. local7
port Enter the port number for communication with the syslog server. 514
server Enter the IP address of the syslog server that stores the logs. No default.
status {disable | enable} Enter enable to enable logging to a remote syslog server. disable