Fortinet Version 3.0 - Manual (Page 56)

FortiBridge Version 3.0 Administration Guide
56 09-30000-0163-20061109
probe setting config CLI commands
probe setting
Use this command to configure how the FortiBridge unit responds when a probe determines that the
FortiGate unit has failed. You can also configure the dynamic IP pattern used by probes and add the
FortiGate serial number, which is used in FortiBridge alert messages.
Command syntax pattern
config probe setting
set
end
config probe setting
unset
end
get probe setting
show probe setting
Example
Use the following command to configure the FortiBridge unit to send alert email and fail open when a
probe detects a failure, set the IP pattern to 2.2.2.* and add the FGT8002803923050 FortiGate serial
number
config probe setting
set action_on_failure alertmail failopen
set dynamic_ip_pattern 2.2.2.*
set fgt_serial FGT8002803923050
end
Related Commands
• probe probe_list {ping | http | ftp | pop3 | smtp | imap}
Keywords and variables Description Default
action_on_failure
{alertmail failopen snmp
syslog}
Set how the FortiBridge unit responds when a probe detects that
the FortiGate unit has failed. You can enter one or more of the
action types separated by spaces. Enter all of the action options
required. If you want to remove an option from the list or add an
option to the list, you must retype the list with the option removed
or added. failopen
dynamic_ip_pattern
.*
Configure the INT 2 and EXT 2 interfaces with dynamic probe IP
addresses. The dynamic probe IP addresses should not conflict
with IP addresses on the network that the FortiGate unit is
connected to. These IP addresses are not visible from the
outside network, but they should not conflict with IP addresses in
packets passing through the FortiBridge unit. You cannot change
the dynamic IP pattern if any probes are enabled. none
fgt_serial The serial number of the FortiGate unit that the FortiBridge unit is
connected to. This number is used in FortiBridge alert messages
to identify the FortiGate unit. none