Fortinet Version 3.0 - Manual (Page 27)

Setting up FortiBridge units Completing the basic FortiBridge configuration
FortiBridge Version 3.0 Administration Guide
09-30000-0163-20061109
27
• Adding an administrator password
• Changing the management IP address
• Changing DNS server IP addresses
• Adding static routes
• Allowing management access to the EXT 1 interface
• Changing the system time and date
• Adding administrator accounts
Adding an administrator password
Add an administrator password to the default admin administrator account to
prevent unauthorized users from connecting to and managing the FortiBridge unit.
To add an administrator password
1 Log in to the CLI.
2 Change the admin administrator password. Enter:
config system admin
edit admin
set password
end
For example:
config system admin
edit admin
set password passWORD
end
Changing the management IP address
Change the FortiBridge unit management IP address so that you can connect to
the FortiBridge CLI from your network (instead of being required to use a direct
console connection). The management IP should be a valid IP address for your
network.
To change the management IP address
1 Log in to the CLI.
2 Change management IP address. Enter:
config system manageip
set ip
end
For example:
config system manageip
set ip 192.168.20.23/24
end
Note: Not all of the following procedures are required to complete the basic FortiBridge unit
configuration. Choose the procedures that apply to your installation.