FUJITSU BX900 S1 - Manual (Page 121)

BX900 S1 Operating Manual 121
Hot-plug components
Figure 43: Removing a dummy connection blade module
Ê Press the handles of the dummy module inward and pull it out of the slot.
Installation is carried out in the reverse order.
I
Keep the dummy modules for future use. If you remove a
connection blade and do not replace it with a new one, you must install a
dummy module in the empty slot.
Installing a single-width connection blade
V
CAUTION!
Make sure you observe the safety notes and the information on handling
electrostatic-sensitive devices in the section
"Modules with Electrostatic-
Sensitive Devices" on page 34 .
Ê Unpack the connection blade.