Fortinet FortiGate-5000 - Manual (Page 63)

FortiSwitch-5003 system Front panel LEDs and connectors
FortiGate-5000 Series Introduction
01-30000-83466-20090108
63
About the ZRE network activity LEDs
The ZRE network activity LEDs show links and network activity for the interfaces
and connections listed in
Table 22 .
Figure 28: FortiSwitch-5003 ZRE network activity LEDs
EXT FLT Off Normal operation.
Yellow Cannot establish a link to a configured interface or another
connection problem external to the FortiSwitch-5003 board.
This LED may indicate issues that do not affect normal
operation.
INT FLT Off Normal operation.
Yellow Failure of internal tests. Indicates a hardware or software
problem with the FortiSwitch-5003 board.
Hot Swap Blue Indicates the FortiSwitch-5003 board is ready to be hot
swapped. During a hot swap, the LED is on. The LED turns off
when the FortiSwitch-5003 board is correctly installed.
Reset
switch Press and hold Reset for three seconds to restart the FortiSwitch-5003
board.
Table 21: FortiSwitch-5003 board front panel LEDs and switches (Continued)
LED State Description
Table 22: ZRE network activity LEDs FortiSwitch-5003 interfaces and connections
ZRE network
activity LED Interface or connection
0 ZRE0 front panel interface.
1 ZRE1 front panel interface.
2 ZRE2 front panel interface.
3 to 14 Base backplane connection to FortiGate-5000 series boards in chassis
slots 3 to 14.
15 Base backplane link. Indicates that the FortiSwitch-5003 board can
connect to the base backplane interface.
ZRE
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0