Leds – Fortinet FortiGate-5000 User Manual
Page 62
FortiGate-5000 Series Introduction
62
01-30000-83466-20090108
Front panel LEDs and connectors
FortiSwitch-5003 system
Figure 27: FortiSwitch-5003 front panel
LEDs
Table 21
lists and describes the FortiSwitch-5003 board front panel LEDs.
MANAGEMENT
SYSTEM
E1
ZRE
LED MODE
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
E0
OK
CLK
INT
EXT
FL
T
HOT SW
AP
RESET
FL
T
CONSOLE
E T H O
R S 2 3 2
Z R E 0
Z R E 1
Z R E 2
Mounting
Knot
Extraction
Lever
10/100/1000Base-T
Ethernet
ZRE0 ZRE1 ZRE2
base backplane interfaces
LED Mode Switch
Mounting
Knot
Extraction
Lever
Out of
Service LED
Power LED
Reset
Switch
Hot
Swap
LED
Management
100Base-TX
Ethernet
ZRE Network
Activity LEDs
(ZRE 0 to 15)
CONSOLE
RJ-45
Serial
Table 21: FortiSwitch-5003 board front panel LEDs and switches
LED
State
Description
Off
Normal operation.
Red
Out of service. The LED turns on if the FortiSwitch-5003 board
fails. The LED may also flash briefly when the board is
powering on.
Green
The FortiSwitch-5003 board is powered on and operating
normally.
Yellow
Caution status. Caution status is indicated by the fault condition
of the CLOCK, OK or INT FLT LEDs.
Off
The board is not connected to power.
System
Off
Normal operation.
E0, E1
Yellow or
Green
Link status of out of band management interfaces (not used).
ZRE 0-15
(ZRE
network
activity
LEDs, LED
Mode
switch
changes
mode)
Green
Link/Activity mode: Blinking to indicate network traffic on this
lists the ZRE LEDs and the
interface that each represents.
Link/Speed mode: 100 Mbps connection.
Yellow
Link/Activity mode: The interface is disabled and cannot
forward packets. (not used)
Link/Speed mode: 1000 Mbps connection.
Off
Link/Activity mode: No link.
Link/Speed mode: 10 Mbps connection.
LED Mode
switch
Change the ZRE network activity LED display mode. Normally the ZRE
network activity LEDs operate in Link/Activity mode. In this mode the LEDs
flash green to indicate a link and to indicate network traffic.
Press this button to switch the ZRE LEDs to Link/Speed mode. In
Link/Speed mode the ZRE LEDs use a solid color to indicate a link. The
color of the LED indicates the speed of the link.
CLK
Flashing
Green
Initialization completed successfully.
OK
Green
Initialization completed successfully.