Fortinet FortiGate-5000 - Manual (Page 60)

FortiGate-5000 Series Introduction
60 01-30000-83466-20090108
FortiSwitch-5003A configurations FortiSwitch-5003A system
Layer-2 link aggregation and redundancy configurations
The FortiSwitch-5003A board supports 802.3ad static mode layer-2 link
aggregation, 802.1q VLANs, and 802.1s Multi-Spanning Tree Protocol (MSTP) for
the fabric channels. You can use these features to configure link aggregation and
support redundant FortiSwitch-5003A configurations to distribute traffic to multiple
FortiGate-5001A or 5005FA2 boards.
Figure 26 shows a basic link aggregation configuration using a single
FortiSwitch-5003A board. In this configuration the external switch is connected to
FortiSwitch-5003A front panel f5 interface. The switch adds VLAN tags to traffic
from the internal and external networks.
Figure 26: Basic link aggregation configuration
Distributed 10-gigabit
data communication
on fabric channel 1
Six FortiGate-RTM-XB2
modules installed in RTM
slots 6, 8, 9, 10, 11, and
13 to provide 10-gigabit
fabric interfaces and
NP2 acceleration for each
FortiGate-5001A board
Internal and external
10-gigabit networks
connected to
FortiSwitch-5003A
front panel interface F7
and to fabric channel 1
External switch
VLAN
tagged
traffic
External
Network
Internal Network
FA N T R AY FA N T R AY FA N T R AY
13 11 9 7 5 3 1 2 4 6 8 10 12 14
5140
CR ITI CAL RESET MAJOR MINOR USER1 USER2 USER3
5140SAP SERIAL 1 SERIAL 2 ALARM
FILTER
1 2
0 1 2
10/100 link/Act
ETH0 Service
RESET
STATUS
Hot Swap
link/Act ETH0 ETH1 10/100 5000SM
10/100 link/Act
ETH0 Service
RESET
STATUS
Hot Swap
link/Act ETH0 ETH1 10/100 5000SM