FUJITSU M3099GH - Manual (Page 85)

7-14
When you set the picking time, you must set as follows:
H E T E R C O N A T R O L
O N
When you set the heater control, you must set as follows:
Setting heater control
1 In Screen 2, press Mode 1 17 times (18 times
for M3099GX/GH) to go to the HEATER
CONTROL screen.
2 Press Mode 2 to display Screen 39. If “ON”
is displayed, the heater control will be done.
If “OFF” is displayed, warming-up will finish
within 30 seconds, if necessary. When the
heater is broken, please set “OFF”. Each
time
Mode 1 is pressed, “ON” and “OFF”
appear alternately. The setting is stored in
EEPROM automatically.
3 Press Mode 2 to display Screen 38. When
you close the setup mode, press Stop .
(Blinking)
Setting hopper time
1 In Screen 2, press Mode 1 16 times (17 times
for M3099GX/GH) to display HOPPER
TIMER screen.
2 Press Mode 2 to display Screen 37.
(The default setting is 7 seconds.)
3 In Screen 37, press Mode 1 until the digit you
want to change blinks. Then press Mode 2
until the value you want to select appears.
(The selectable range is from 0 to 30 seconds
in steps of 1 second.)
4 Press Mode 1 and Mode 2 at the same time to
display Screen 36. The settings are stored in
EEPROM.
5 When you close the setup mode, press
Stop .
< > < > S E T U P M O D E
T I M E R H O P P E R
S X X
T I M E R H O P P E R
< > < > S E T U P M O D E
H E T E R C O N A T R O L
15-Chap. (7) 98.2.20, 10:59 AM 14