FUJITSU M3099GH - Manual (Page 83)

7-12
Setting Product-ID (M3099GX / GH)
When you set Product-ID, you must set as follows:
(Blinking)
1 In Screen 2, press Mode 1 13 times to display
PRODUCT-ID SET screen.
2 Press Mode 2 to display Screen 29.
(The default setting is “M3099GH” in case of
M3099GH and “M3099G”in case of
M3099GX.)
3 In Screen 29, press Mode 1 to select Product-
ID. Each time Mode 1 is pressed, M3099G,
M3099GH or M3096G apear in case of
M3099GH, and M3099G or M3096G at each
time you press
Mode 1 in case of M3099GX.
4 Press Mode 2 to display Screen 28.
The settings are stored in EEPROM.
5 When you close the setup mode, press
Stop .
When you set the picking start time, you must set as follows:
Setting picking start time
1 In Screen 2, press Mode 1 13 times (14 times
for M3099GX/GH) to display PICK START
TIMER screen.
2 Press Mode 2 to display Screen 31.
(The default setting is 1 second.)
3 In Screen 31, press Mode 1 until the digit you
want to change blinks. Then press Mode 2
until the value you want to select appears.
(The selectable range is from 0.2 to 29.8
seconds in steps of 0.2 seconds.)
4 Press Mode 1 and Mode 2 at the same time to
display Screen 30.
The settings are stored in EEPROM.
5 When you close the setup mode, press
Stop .
< > < > S E T U P M O D E
R P O D U E C T - I D S T
X X X X X X
R P O D U E C T - I D S T
< > < > S E T U P M O D E
C I P K S M T A R T T I E R
X X . X S
C I P K S M T A R T T I E R
15-Chap. (7) 98.2.20, 10:58 AM 12