FUJITSU M3099GH - Manual (Page 75)

7-4
8 Press Mode 1 and Mode 2 at the same
time to display Screen 4. The settings
are stored in EEPROM.
When you close, press
Stop .
Mode Details
ON/OFF “OFF” is default setting.
1 “1” is default setting.
This mode is used when a batch of documents whose length are same is scanned.
When a document with tears and wrinkles is scanned, the scanner may also fail to
detect the double-feed.
2 This mode is used when a batch of documents whose length and thickness are same is
scanned.
However, when a thin document is scanned, the scanner may fail to detect the double-
feed rarely.
\In this case, please test scanning of a thin document in advance.
N o
I P C - 2 S E T
1 AT Screen 2, press Mode 1 twice to
go to the IPC-2 SET screen.
2 Press Mode 2 to see Screen 9 or 10.
If “No” is displayed, IPC-2 pre-set mode
is not used.
If pettrn number (“1”-“5”) is displayed,
IPC-2 pre-set mode is used.
“No” or number status flips each time you
press
Mode 1 .
(The default setting is “No”.)
Setting IPC-2 pre-set mode
When you set the using of IPC-2 pre-set mode, you must set as follows:
< > < > S E T U P M O D E
I P C - 2 S E T
15-Chap. (7) 98.2.20, 10:56 AM 4