FUJITSU M3099GH - Manual (Page 78)

7-7
1 In Screen 2, press Mode 1 3 times to
display PAPER COUNT RESET screen.
2 Press Mode 2 to display Screen 14.
You may see current paper count.
If you want to reset the count,press
Mode 2 . And you can see Screen 15 for 3
seconds.
If you do not want it, press
Mode 1 to go to
Screen13.
3 When you close the setup mode, press
Stop .
Reset of abrasion counter
When you reset the abrasion counter, you must set as follows:
Setting buzzer
1 In Screen 2, press Mode 1 4 times to
display BUZZER SET screen.
2 Press Mode 2 to display Screen 17.
Select “ON” to ring the buzzer when an
error occurs. Each time
Mode 1 is
pressed, “ON” and “OFF” appear
alternately. The setting is stored in
EEPROM automatically.
3 Press Mode 2 to return to Screen 16.
When you close the setup mode, press
Stop .
When you set the using of buzzer, you must set as follows:
B U Z E R S E Z T
O N
< > < > S E T U P M O D E
P E R C O U N R E S P A E T T
C O U N T R E S E T 6 5 4 3 2 1
N o - M o d e 1 Y e - M o d e 2 s
R E S E T i n i s h 0 0 0 0 0 F ! !
< > < > S E T U P M O D E
R E P C K S E I T P
15-Chap. (7) 98.2.20, 10:57 AM 7