FUJITSU M3099GH - Manual (Page 37)

3-2
Button Specification and Reading Mode Setting
(M3099EX/EH)
This section describes the button specifications and setup details for each of the simplex (front-side),
duplex (front-side) and duplex (back-side) reading modes.
When reading mode is set by the command from the host computer, the following button operation is
not required.
button pressed
button pressed
(Blinking)
(Blinking)
Duplex
button pressed
S F A 4 4 0 0 L . >
D F 4 0 0 L . > A 4
D B L . > A 4
D
D
F A 4 4 0 0 L
L
.
.
>
> B
D
D
A 4 4 0 0 L
L
.
.
>
> B
F
Front/
Back
D
D
F A 4 4 0 0 L
L
.
.
>
> B
Front/
Back
button
This button is valid only in the duplex
reading mode. Press this button to toggle
the read side between front and back.
“F” and “B” blink alternately for the setting of
front or back-side.
Front/
Back
Duplex button
This button is used to select simplex or
duplex document reading mode. Press this
button to toggle the display between the
initial screens of the simplex and duplex
reading modes.
07-Chap. (3) 98.2.20, 10:51 AM 2