FUJITSU M3099GH - Manual (Page 82)

7-11
S C I - I D S E S T
5
Setting RS-232C transfer rate (M3099EX / EH)
When you set RS-232C transfer rate, you must set as follows:
Setting SCSI-ID (M3099GX/GH)
1 In Screen 2, press Mode 1 12 times to
display SCSI-ID SET screen.
2 Press Mode 2 to display Screen 27.
(The default setting is “5”.)
3 In Screen 27, press Mode 1 to change
SCSI-ID. Each time Mode 1 is pressed,
SCSI-ID changed from 0 to 7.
4 Press Mode 2 to display Screen 26.
The settings are stored in EEPROM.
5 When you close the setup mode, press
Stop .
1 In Screen 2, press Mode 1 12 times to
display RS-232C BAUD screen.
2 Press Mode 2 to display Screen 25.
(The default setting is 4800 bps.)
3 In Screen 25, press Mode 1 until the rate
you want to select blinks.
4 Press Mode 2 to display Screen 24.
The settings are stored in EEPROM.
5 When you close the setup mode, press
Stop .
When you set the picking start time, you must set as follows:
(Blinking)
< > < > S E T U P M O D E
R S 2 2 C B A U D 3
< > < > S E T U P M O D E
0 0 6 9 : 4 8 : 0 0 : 2 4 0 0 1 2 0 0
< > < > S E T U P M O D E
S C I - I D S E S T
15-Chap. (7) 98.2.20, 10:57 AM 11