FUJITSU M3099GH - Manual (Page 84)

7-13
When you set the picking time, you must set as follows:
Setting picking time
(Blinking)
(Blinking)
1 In Screen 2, press Mode 1 14 times (15
times for M3099GX/GH) to display PICK
TIMER screen.
2 Press Mode 2 to display Screen 33.
(The default setting is 2 seconds.)
3 In Screen 33, press Mode 1 until the digit
you want to change blinks. Then press
Mode 2 until the value you want to select
appears. (The selectable range is from 0.5
to 99.5 seconds in steps of 0.5 seconds.)
4 Press Mode 1 and Mode 2 at the same time
to display Screen 32.
The settings are stored in EEPROM.
5 When you close the setup mode, press
Stop .
Setting time-out limit
1 In Screen 2, press Mode 1 15 times
(16 times for M3099GX/GH) to display
TIME-OUT SET screen.
2 Press Mode 2 to display Screen 35.
(The default setting is 30 seconds.)
3 In Screen 35, press Mode 1 until the digit
you want to change blinks. Then press
Mode 2 until the value you want to select
appears. (The selectable range is from 1 to
1999 seconds in steps of 1 second.)
4 Press Mode 1 and Mode 2 at the same time
to display Screen 34. The settings are
stored in EEPROM.
5 When you close the setup mode, press
Stop .
T I M E E - O U T S T
X X X X S
< > < > S E T U P M O D E
T I M E E - O U T S T
< > < > S E T U P M O D E
. X S X X
< > < > S E T U P M O D E
P I C E K T I M R
15-Chap. (7) 98.2.20, 10:59 AM 13