FUJITSU M3099GH - Manual (Page 69)

6-5
13 In Screen 1, press Mode 1 11 times to
display INK RESET screen.
14 Press Mode 2 to display Screen 13. If you
want to reset the counter, press Mode 2 .
And you can see Screen 14 for 3 seconds.
If you do not want it, press
Mode 1 to go
Screen 12.
Go to 7 to close the job.
How to test the printing using the operator panel
You can check the print result as follows:
How to reset the print head life counter
You must reset the print head life counter when you replace the print head.
< < C M O D E E > >
T E S T x x : S T A R T
15 Turn the endorser on by following the
procedure of “page 6-2, How to set the
endorser ON (or OFF)”.
16 Turn the power of the scanner on while
pressing Mode 2 . The LCD displays MAIN-
TENANCE MODE initial screen.
17 Press Mode 2 once, then press Mode 1 once.
Place a document on the stacker, then
press
Start .
NOTE
• The scanner prints 5-digit numbers counting in increment of one from the
initial number.
• Before pressing Start you can set the document size, resolution and so
on (See Chapter 3).
R E S E T i n i s h F ! !
I N K R E S E T
N o - M o d e 1 Y e - M o d e 2 s
< > < > S E T U P M O D E
I N K R E S E T
13-Chap. (6) 98.2.20, 10:55 AM 5