HP DVD100I - Manual (Page 20)

hp dvd-writer hp dvd-writer hp dvd-writer hp dvd-writer dvd100i dvd100i dvd100i dvd100i Technical Support Solutions Guide 10/25/01 Physical Specifications
20 20 20 20
⇐ ⇐ ⇐ ⇐ ⇒ ⇒ ⇒ ⇒
Table 12 Table 12 Table 12 Table 12 ATA-2 Signals Master/Slave and Cable Select Master/Slave and Cable Select Master/Slave and Cable Select Master/Slave and Cable Select
Drive selection is made with jumpers on the Master, Slave, or Cable Select (CSEL)
jumper block at the back end of the drive. The drive can be configured as Master,
Slave, or Cable Select. The selection process in ANSI specification X3T10/0948D ATA-
2 Revision 4c is used.
Figure 7 Figure 7 Figure 7 Figure 7 Drive Jumpers
Table 13 Table 13 Table 13 Table 13 Drive Master/Slave/CSEL Jumpers
Pin # Signal Signal Pin #
1 -RESET Ground 2
3 DD7 DD8 4
5 DD6 DD9 6
7 DD5 DD10 8
9 DD4 DD11 10
11 DD3 DD12 12
13 DD2 DD13 14
15 DD1 DD14 16
17 DD0 DD15 18
19 Ground keypin 20
21 DMARQ Ground 22
23 -DIOW Ground 24
25 -DIOR Ground 26
27 IORDY SPSYNC/CSEL 28
29 -DMACK Ground 30
31 INTRQ -IOCS16 32
33 DA1 -PDIAG 34
35 DA0 DA2 36
37 -CS0 -CS1 38
39 -DASP Ground 40
Jumper Setting Meaning
M Master - Drive is set to Master
S Slave - Drive is set to Slave
CS Cable Select - Cable and drive position determines setting
None Not Allowed
M A S T E R
C S E L
S L A V E
J U M P E R
Product Information Drive Specifications Interfaces Installation and Configuration
Drive Operation Tips and Techniques Software Maintenance
Troubleshooting Warranty and Support Release Notes Discontinued Products