Hand Held Products DOLPHIN 9500 - Manual (Page 30)

Terminal Setup
Use the
Up-Arrow
and
Down-Arrow
keys to navigate the menu, and press
Enter
to select
enu option is described below.
ontains the terminal IP address, the Subnet Mask and the Router IP address.
Edit Server/Host IPs
the Setting the Servers
anager, or if you wish to change those settings using the
terminal menus, select this option and enter up to four Host IP addresses as required.
the highlighted option. Each m
Edit Mobile Unit IP
The IP list c
Enter the
appropriate address and select <F3 > to save and/or <F7 > to Quit.
IP 206.232.71.38
SN 255.255.255.0
RT 206.232.71.1
Save Quit
If the host IP address(es) were not pre-configured as described in
section of Configuring the M
Host 0
IP 206.183.67.155
Port 23__
Save Quit
Press <
F3
> to save the configurations.
Edit Radio Option
This function acts as a password to join the radio network. Terminals associating with an
Access Point must supply a matching value, determined by their configurations, or their
association requests will be ignored.
Edit License Key
The client software can be authorized automatically, as described in the next section,
Authorizing PowerNet. This menu option permits authorization of each terminal
manually. Select this option to obtain the terminal's Identification Code, which is used to
obtain the Authorization code from the Connect web site, as described in the next section.
The 12-digit value displayed at the top of the terminal screen is the Identification Code
for the terminal.
ID tsunami____________
Save Quit
2-20 Supported Equipment Manual
• January, 2006