Hand Held Products DOLPHIN 9500 - Manual (Page 16)

Terminal Setup
Setting the Servers
The Servers are the Telnet host systems the terminals will access.
To set these addresses from the
Settings
menu, click on
Servers
and then click on
Add
.
Enter the name of each server, its IP address and IP port (normally 23 for Telnet servers),
and emulation type. Then click on
OK
.
Repeat this step for each Telnet server the terminals are required to access. If an error is
made in the name, IP address, IP port number, or terminal emulation type, click on the
E
line that is in error and then click on the
dit
button to make the corrections. Use the
Load
button if you want to load an .svr file. Use the
Save As
button if you want to save
your file as an .svr file.
Setting Terminal Operations
Select
Terminal Operation from under Settings in Twin Client Manager.
2-6 Supported Equipment Manual
• January, 2006