beautypg.com

Ection, Echnical – NewTek TalkShow VS-100 User Manual

Page 81

background image

Page | 73

When you really want to burrow down into connection detail at a ‘molecular’ level, you
can refer to the Call Technical Info
pane, at upper-right (Figure 74).

It would be hard to overstate the
level of arcane detail provided,
including excruciating data on the
Network connection, System resource
usage (for both TalkShow™ and the
remote caller), as well as both audio
and video streams.

Below you will find a breakdown of
the

various

individual

datum

provided.

Network – Describes the network
connection to Skype TX™.

o Jitter – The difference between the minimum and maximum ping times,

expressed in milliseconds (lower is better).

o Round Trip –The time it takes, in milliseconds, for a signal to be sent from Skype

TX to the remote caller and back (lower is better).

o Transport – Possible values are (from best to worst): UDP, UDP with Relay, TCP,

TCP with Relay. UDP and TCP are IP protocols, with UDP providing the best
performance. Relaying is required where a direct connection cannot be made,
but this limits performance. In this case, lower performance might mean a
lower resolution and a less reliable connection.

o UDP Status – A value of ‘good’ indicates the UDP connectivity is possible in the

relevant direction. A value of ‘bad’ indicates that there is a problem, such as a
router configuration issue. Good is best.

o Packet Count – The number of media packets which have been transported.

FIGURE 74