NewTek TalkShow VS-100 - Manual (Page 43)

Page | 35
You may also want to go into the Return pane and enable the switch labeled Copy to Ch.
3 and 4 in the Audio settings group (Figure 33). When this feature is enabled, the return
audio feed from the studio is also stored in the file.
FIGURE 34
Finally, click the Record button in TalkShow’s Dashboard (Figure 34). If a call is active,
TalkShow will begin recording. When the call ends, the current file is closed; beginning a
new call will automatically generate a new file.
You can take a snapshot of the remote
caller at any point during an active Skype™
video call. To do so, click the camera icon
beneath the upper-right preview monitor,
which will subsequently display the still
image you grab.
This image can serve as a fallback video
display should the incoming Skype video
signal either be lost completely, or fall
below a specified minimum video resolution
due to poor network conditions or other factors
You can update the grabbed still image at any time by clicking the ‘camera’ again.
Note: T he snapshot image persists only for the duration of the current call. If you call the
same contact again , you will need to take a new snapshot.
FIGURE 35